Installing Service Pack 6A; Ultra Dma Setting For The Hdd - Epson MR Series Technical Reference Manual

Uninstalling the network driver
Uninstalling cannot be done.

Installing Service Pack 6a

This is installed by the exclusive installation program.
1. Insert the Service Pack 6a CD-ROM in the CD-ROM drive. Execute the
"Nt4sp6\Sp6i386.exe" on the Service Pack 6a CD-ROM.
2. The Setup Wizard starts, the License Agreement dialog box is displayed. Select [Accept the
license agreement] and click Install.
3. Installing is completed; then the dialog box is displayed. Click Restart.

Ultra DMA Setting for the HDD

You can set the HDD to the DMA mode by following the steps below.
1. Set the Service Pack 6a CD-ROM to the CD-ROM drive. Execute the
"Nt4sp6\Support\Utils\I386\Dmacheck.exe" in the Service Pack 6a CD-ROM.
2. ATAPI DMA Support dialog box appears. Set the DMA Detection Status of the Current
DMA Usage Channel 0 to enabled and click OK.
3. A warning dialog box appears. Click Yes.
Rev. I
MR Series Technical Reference Manual
OS and Drivers 4-31