Removing the Components (SERIAL NO. *xxxx00xxxx*)
When removing the components for which the SERIAL NO is *xxxx01xxxx*, see page 9-27.
MSR Assembly or LED Circuit Board
1. Remove the rear cover. (See page 9-8.)
2. Disconnect 1 screw (S01) and remove the front cable clamp.
3. Remove 3 screws (S01) securing the MSR assembly to the front cover. And disconnect the
connector of the LED cable from the MSR assembly.
LED cable
screw (S10)
cable clamp
screw (S01)
)
Follow the steps below to assemble the unit.
1. Confirm the connection of the cables, following the figure above.
2. Install the rear cover. (See page 9-8.)
To replace the LED circuit board, follow the steps below..
1. Remove the rear cover. (See page 9-8.)
2. Remove 3 screws securing (S01) the MSR assembly to the front cover. And disconnect the
connector of the LED cable from the MSR assembly. (See the illustration above.)
3. Remove 1 screw (S03) securing the LED circuit board.
screw (S03)
LED circuit board
9-10 Disassembly and Assembly
MSR
screw (S10)
Rev. I