Epson MR Series Technical Reference Manual page 232

4. Disconnect the 3 cables from the LCD circuit board, and remove 2 screws (1050) holding 2
ground wires and lift up the ground wires. After that remove the 2 screws (1050) securing
the plate.
screw (1050) and
ground wire
cables connected to
the switch circuit board
cables
screw (1050)
CAUTION:
Remove the cable on the right side very carefully because its connection is not
strong.
5. Remove the LCD circuit board.
To install, reverse the removal procedure.
9-16 Disassembly and Assembly
cable
cable: See
Caution below
screw (1050) and
ground wire
LCD circuit board
screw (1050)
Rev. I