NEC Univerge SV8100 Features And Specifications Manual page 986

Issue 1.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit Setup
11-10-04 Service Code Setup (for System
Administrator) – Storing Common
Speed Dialing Numbers
11-10-05 Service Code Setup (for System
Administrator) – Storing Group
Speed Dialing Numbers
11-11-39 Service Code Setup (for Setup/
Entry Operation) – Station Speed
Dial Number Entry
11-12-10 Service Code Setup (for Service
Access) – Station Speed Dialing
11-12-11 Service Code Setup (for Service
Access) – Group Speed Dialing
13-01-01 Speed Dialing Option Setup –
Speed Dialing Auto Outgoing Call
Mode
13-01-03 Speed Dialing Option Setup –
Number of Common Speed Dialing
Bins
13-02-01 Group Speed Dialing Bins
2 - 962
Description/Comments
If dial tone detection is enabled, be
sure to allocate at least one circuit
for dial tone detection (Type 0 or 2).
Used to customize the service code
used for storing Common Speed
Dialing Numbers.
Used to customize the service code
used for storing group speed dialing
numbers.
Used to customize the service code
used for entering station speed dial
numbers.
Assign Service code for accessing
System Speed Dial bins (default
Used to customize the service code
for group speed dialing.
Designate trunk or intercom
outgoing mode, (default: 0, trunk).
Designate the bins the system uses
for System Speed Dialing.
Designates the starting bin number
the system uses for Group Speed
Dialing.
UNIVERGE SV8100
Assigned Data
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource 97~160
= 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
MLT
(default = 753)
MLT
(default = 754)
MLT, SLT
(default = 755)
MLT, SLT
# #
2). (default = 2)
MLT, SLT
#
(default = 4)
0 = Trunk Outgoing
Mode
1 = Intercom Outgoing
Mode
(default = 0)
0~2000
0 = No Common Speed
Dialing
(default = 1000)
01~64
(default not assigned)
Speed Dial – System/Group/Station
Level
1 2 3