NEC Univerge SV8100 Features And Specifications Manual page 754

Issue 1.0
Related Features
Handsfree Answerback/Forced Intercom Ringing
Handset Mute
Programmable Function Keys
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
15-07-01 Programmable Function Keys
20-02-11 System Options for Multiline
Telephones – Handsfree
Microphone Control
2 - 730
Description/Comments
If an extension needs handset
microphone cutoff, program a
Handset Transmission Cutoff key
(code 40). To program a MIC Cutoff
key, use code 02 as the entry. The
MIC Cutoff key mutes conversation
on a handsfree call, but the
Handset Transmission Cutoff key
mutes the handset transmission on
a non-handsfree call.
Use this option to control the setting
for multiline terminal handsfree
microphone after being
disconnected and reconnected. If
set to 0, the microphone is always
off when the terminal is
reconnected. If set to 1, the
microphone remains in the same
state it was in when the terminal is
reconnected.
UNIVERGE SV8100
Assigned Data
1
For Line Keys: 1~48
0 ~ 99 (Normal
Function Code)
(default = Service
Code 751)*
00 ~ 99
(Appearance Function
Code) (default =
Service Code 752)
0 = Off
1 = On
(default = 1
Microphone Cutoff
Level
2 3