NEC Univerge SV8100 Features And Specifications Manual page 384

Issue 1.0
Speed Dial – System/Group/Station
T1 Trunking (with ANI/DNIS Compatibility)
Trunk Group Routing
Trunk Groups
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit
Setup
14-02-05 Analog Trunk Data Setup – Dial
Tone Detection for Manually
Accessed Trunks
14-02-11 Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
2 - 360
Description/Comments
If dial tone detection is enabled, be
sure to allocate at least one circuit
for dial tone detection [ICM/Trunk
(0) or Trunk (2)].
Use this option enable/disable dial
tone detection for directly
accessed trunks. If disabled, the
system outdials on the trunks
without monitoring for dial tone.
If enabled, the system skips over a
trunk if dial tone is not detected.
This option pertains to calls placed
using Call Appearance (CAP)
Keys, Speed Dial, ARS, Last
Number Redial or Save Number
Dialed. It does not pertain to line
key or Direct Trunk Access calls.
UNIVERGE SV8100
Assigned Data
1
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used
(default = 0)
0 = Disable
1 = Enable
(default = 0)
Dial Tone Detection
Level
2 3