NEC Univerge SV8100 Features And Specifications Manual page 259

UNIVERGE SV8100
Program
Program Name
Number
20-07-12 Class of Service Options
(Administrator Level) – Trunk
Port Disable
20-08-02 Class of Service Options
(Outgoing Call Service) – Trunk
Outgoing Calls
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
21-01-15 System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
21-01-16 System Options for Outgoing
Calls – Supervise Dial Detection
Timer
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
21-02-01 Trunk Group Routing for
Extensions
21-15-01 Individual Trunk Group Routing
for Extensions
24-02-07 System Options for Transfer –
Trunk-to-Trunk Transfer Release
Warning Tone
24-02-10 System Options for Transfer –
Disconnect Trunk to Trunk Timer
SV8100 Features and Specifications Manual
Description/Comments
Turns Off (0) or On (1) the
extension ability to use the Trunk
Port Disable feature.
Turns Off (0) or On (1) outgoing
trunk calling for the extension.
Turns Off (0) or On (1) the
extension ability to use Continued
Dialing, which allows DTMF signal
sending while talking on extension.
Enable or Disable the Outgoing
Disable on Incoming Line feature.
With the Outgoing Disable on
Incoming Line feature, if dial tone is
not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Assign Program 14-06 routes to
extensions.
Designate the trunk route accessed
when a user dials the Alternate
Trunk Route Access Code. Refer to
Trunk Group Routing to set up
outbound routing.
Timer starts when a trunk begins
talking with another trunk (for
example: Trunk-to-Trunk Transfer,
outgoing from trunk, Tandem
Trunking). When this time expires, a
warning tone is heard.
Timer starts after the Warning Tone
is heard (24-02-07). When time
expires, the trunk is disconnected.
Assigned Data
1
0 = Off
1 = On
(default = 0 for
COS 1~14)
(default = 1 for
COS 15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Off
1 = On
(default = 1 for
COS 1~15)
0 = Disable
1 = Enable
(default = 1)
0~64800 (seconds)
(default = 20 seconds)
Digits 0~9
(default = 4)
0~100
(0 = No Setting)
(default = 1)
0~100
(0 = No Setting)
(default = 0)
0~64800 (seconds)
(default = 1800
seconds)
0~64800 (seconds)
(default = 0 seconds)
Issue 1.0
Level
2 3
2 - 235