NEC Univerge SV8100 Features And Specifications Manual page 165

UNIVERGE SV8100
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-09-01 DTMF and Dial Tone Circuit
Setup
11-11-45 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward All (Split)
11-11-46 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward Busy (Split)
11-11-47 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward No Answer (Split)
11-11-48 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward Busy/No Answer
(Split)
14-01-13 Basic Trunk Data Setup –
Trunk-to-Trunk Transfer
14-04-01 Behind PBX Setup
SV8100 Features and Specifications Manual
Description/Comments
Allocate the circuits on the
CD-CP00-AU ETUs for either
DTMF receiving or dial tone
detection. Program 14-01-13 Basic
Trunk Data Setup – Loop
Supervision Enable (1) loop
supervision for each trunk that
should be able to use Call
Forwarding – Centrex.
Used to assign the Call Forward All
Split Service Code.
Used to assign the Call Forward
Busy Split Service Code.
Used to assign the Call Forward No
Answer Split Service Code.
Used to assign the Call Forward
Busy No Answer Split Service
Code.
Use this option to Enable or Disable
loop supervision for the trunk.
Indicate if the trunk is installed
behind a PBX (1) or not (0). There
is one item for each of the Night
Service Modes.
Assigned Data
1
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
MLT, SLT
(default not assigned)
MLT, SLT
(default not assigned)
MLT, SLT
(default not assigned)
MLT, SLT
(default not assigned)
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
0 = Stand Alone
(Trunk)
1 = Behind PBX (PBX)
2 = Not Used
3 = CTX assume 9
(default = 0)
Issue 1.0
Level
2 3
2 - 141