NEC Univerge SV8100 Features And Specifications Manual page 130

Issue 1.0
Program
Program Name
Number
44-05-04 ARS/F-Route Table – Beep Tone
44-05-05 ARS/F-Route Table – Gain Table
Number for Internal Call
44-05-06 ARS/F-Route Table – Gain Table
Number for Tandem Connections
44-05-07 ARS/F-Route Table – ARS Class
of Service
44-05-08 ARS/F-Route Table – Dial
Treatment
44-05-09 ARS/F-Route Table – Maximum
Digit
44-05-10 ARS/F-Route – CCIS over IP
Destination Point Code
44-05-11 ARS/F-Route – Network Specified
Parameter Table
44-06-01 Additional Dial Table
2 - 106
Description/Comments
For each ARS/F-Route table (1~500)
assign a priority number (1~4).
Select whether or not a beep is
heard if a lower priority trunk group is
used.
For each ARS/F-Route table (1~500)
assign a priority number (1~4).
Select the gain table number to be
used for internal calls (0~500).
For each ARS/F-Route table (1~500)
assign a priority number (1~4).
Select the gain table number to be
used for the tandem call (defined in
Program 44-07).
For each ARS/F-Route table (1~500)
assign a priority number (1~4).
Select the Class of Service to be
used for ARS (0~16). Extension ARS
COS is determined in Program 26-
04-01.
For each ARS/F-Route table (1~500)
assign a priority number (1~4).
Select the Dial Treatment to be used
(0~15). The Dial Treatments are
defined in Program 26-03-01
Input the maximum number of digits
to send when using the F-Route.
For each ARS/F-Route table
(1~500). Set the CCIS over IP
Destination Point Code (0~16367).
For each ARS/F-Route table (1~500)
assign the priority (1~4). Assign the
Network Specified Parameter Table
(0~16).
If an Additional Dial Number Table is
entered in Program 44-05-03, define
the additional dial table (1~1000) to
add digits in front of the dialed ARS/
F-Route number (24 digits max: 1-9,
#
0 , Pause). To enter a wild card/
don't care digit, press Line Key 1 to
enter a P (pause) symbol.
UNIVERGE SV8100
Assigned Data
0 = Off (No Beep)
1 = On (Beep)s
(default = 0)
0~500
0 = No Setting
(default = 0)
0~500
0 = No Setting
(default = 0)
0~16
(default = 0)
0~15
(default = 0)
0~24
(default = 0)
0~16367
(default = 0)
0~16
(default = 0)
Up to 24 digits
Enter: 1~9, 0, , #,
Pause (press line key 1
to enter a pause)
(default not assigned)
Automatic Route Selection
Level
1 2 3