NEC Univerge SV8100 Features And Specifications Manual page 779

UNIVERGE SV8100
Program
Program Name
Number
34-01-01 E&M Tie Line Basic Setup – DID/
E&M Start Signaling
34-01-03 E&M Tie Line Basic Setup – E&M
Dial-In Mode
34-01-04 E&M Tie Line Basic Setup – E&M
Line Dial Tone
34-01-05 E&M Tie Line Basic Setup –
System Toll Restriction
34-02-01 E&M Tie Line Class of Service
34-03-01 Trunk Group Routing for E&M
Tie Lines
34-04-01 E&M Tie Line Toll Restriction
Class
34-05-01 Tie Line Outgoing Call
Restriction
34-06-01 Add/Delete Digit for E&M Tie
Line – Delete Digit
SV8100 Features and Specifications Manual
Description/Comments
Enter 0 for 2nd dial tone, 1 for
wink, 2 for immediate, or 3 for
delay start signaling. To set
outgoing signaling, refer to
Program 14-02-01.
Determine if the incoming Tie Line
call should be directed as an
intercom call or if it should follow
the DID Translation Table in
Program 22-11-01.
Enter (1) if the Tie Line should
send dial tone to the calling
system once the call is set up.
Enter (0) if the Tie Line should not
send dial tone.
Determine if an incoming Tie Line
call should be subject to Toll
Restriction.
Assign the Tie Line Class of
Service (1~15). Use Program
20-14-01 to set the Tie Line Class
of Service options. You cannot use
Program 20-06 ~ Program 20-17
to assign Class of Service to Tie
Lines.
Use this program to assign the
trunk group route chosen when a
user seizes a Tie Line and dials 0.
Set Trunk Group Routing in
Program 14-06-01. If the system
has ARS, dialing 0 accesses ARS.
If the system uses Toll Restriction,
enter a Toll Restriction Class
(1~15) for each Tie Line. The
system uses the class you enter in
Program 21-05-01. You cannot
use Program 21-04 to assign Toll
Restriction to Tie Lines.
This program lets you build a
restriction matrix for trunk calls
placed over a Tie Line. For each
Tie Line trunk group, enable (0) or
disable (1) outgoing access to
each CO trunk group.
Some Tie Line networks pass the
location number and extension
number to the remote side. If the
system should ignore these digits,
use this program to define the
number of digits which should be
deleted for a call.
Assigned Data
0 = 2nd Dial Tone
1 = Wink (default)
2 = Immediate
3 = Delay
(default = 2)
0 = Specify Extension
Number (Intercom)
1 = Use Conversion
Table (NTT)
(default = 0)
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
0 = No (Off)
1 = Yes (On)
(default = 0)
Day/Night Mode
1~8
Class: 1~15
(default = 1)
0~100
(0 = Setting)
(default = 1)
1~15
(default = 2)
0 = Enable
(Y-Tandem)
1 = Disable
(N-Tandem)
(default = 0)
0~255
(255 = delete all digits)
(default = 0)
Issue 1.0
Level
1 2 3
2 - 755