NEC Univerge SV8100 Features And Specifications Manual page 313

UNIVERGE SV8100
Related Features
None
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
11-12-08 Service Code Setup (for Service
Access) – Barge-In
11-12-47 Service Code Setup (for Service
Access) – Call Waiting Answer/
Split Answer
11-12-57 Service Code Setup (for Service
Access) – Tandem Trunking
11-12-58 Service Code Setup (for Service
Access) – Transfer Into
Conference
11-16-02 Single Digit Service Code Setup
– Barge-In
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
15-02-24 Multiline Telephone Basic Data
Setup – Conference Key Mode
SV8100 Features and Specifications Manual
Description/Comments
Determine what the service code
should be for an internal party to
use the Barge-In feature.
If required, use this program to
change the code users dial to Split
while on a call.
With two trunks in Conference
#
press Hold and dial 8 and the
Conference/Tandem happens.
If required, change the service code
used to transfer a call into a
Conference call.
Use to customize the one-digit
Service Codes used for Barge-In.
Use to select the CODEC gain type
used by the trunk when it is part of
an unsupervised conference.
This option allows an extension
Conf key to be programmed for
Conference or for Transfer. When
set for Transfer (1), the user places
a call on hold, dials the extension to
which it should be transferred, the
presses the Conf key. The call is
then transferred. When set for
Conference (0), with an active call,
the user presses the Conf key,
places a second call, then presses
the Conf key twice. All the calls are
then connected.
Assigned Data
1
MLT, SLT
(default = 710)
SLT
(default = 794)
MLT, SLT
#
(default = 8)
MLT, SLT
(default = 624)
(default not assigned)
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
0 = Conference
1 = Transfer
(default = 0)
Issue 1.0
Level
2 3
2 - 289