NEC Univerge SV8100 Features And Specifications Manual page 388

Issue 1.0
Guide to Feature Programming
The Level 1, Level 2 and Level 3 columns indicate the programs that are assigned when programming
this feature in the order they are most commonly used. These levels are used with PCPro and WebPro
wizards for feature programming.
Level 1 – these are the most commonly assigned programs for this feature.
Level 2 – these are the next most commonly assigned programs for this feature.
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
20-06-01 Class of Service for Extensions
20-08-05 Class of Service Options
(Outgoing Call Service) – Dial
Number Preview (Preset Dial)
Operation
To use Dial Number Preview to place a call (multiline terminal only):
1. Do not lift the handset or press Speaker.
2. To preview any number, dial the number you want to call.
With VRS installed, you must press
To preview a Speed Dial – System/Group number, press Redial and dial the
Speed Dial – System/Group bin number you want to call.
The number is displayed.
3. To dial out the displayed trunk number, press a Line/Trunk Group key.
If the previewed number as a trunk access code (e.g., 0), you can press Speaker instead.
- OR -
To dial an Intercom number, press Speaker.
- OR -
To cancel the number without dialing it out, press Hold.
2 - 364
Description/Comments
Assign a Class of Service (1~15) to
extensions.
Turns Off or On an extension
ability to use Dial Number Preview.
to preview the number.
UNIVERGE SV8100
Assigned Data
1
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
0 = Off
1 = On
(default = 1 for
COS 1~15)
Dialing Number Preview
Level
2 3