NEC Univerge SV8100 Features And Specifications Manual page 406

Issue 1.0
Program
Program Name
Number
22-12-01 DID Intercept Ring Group
22-13-01 DID Trunk Group to
Translation Table Assignment
25-01-01 VRS/DISA Line Basic Data
Setup – VRS/DISA Dial-In
Mode
25-01-03 VRS/DISA Line Basic Data
Setup – VRS/DISA Transfer
Alarm
25-02-01 VRS/DISA VRS Message
25-03-01 VRS/DISA Transfer Ring Group
With Incorrect Dialing
2 - 382
Description/Comments
For each DID Translation Table,
program the DID Intercept
destination. The destination can be a
Ring Group, In-Skin/External Voice
Mail, or Centralized Voice Mail. This
program is used when there is no
destination programmed in Program
22-11-05. It is unrelated to Program
22-11-06 and Program 22-11-07.
Assign the DID trunk groups to
translation tables. If all the DID
trunks use the same type of DID
service, you may have only one DID
trunk group and one DID Translation
Table (with many entries).
Determine whether the system
should use option 0 (Extension
number/Service code specify) or
option 1 (Use dial conversion table)
for calls.
Determine whether the system
should use option 0 (Normal) or
option 1 (Alarm) for calls.
For each trunk port and each night
mode, select the message source (0
= No Message, 1 = VRS, 2 = ACI, 3
=S LT), assign the VRS message
number to be used as the
Automated Attendant Message for
each trunk, which is assigned as
VRS/DISA [with VRS = 01~48 (VRS
message number), with ACI = 1~4 or
01~16 (ACI group number), with SLT
= 1~8 or 01~64 (Department Group
number)].
For each trunk port, set what
happens to a call when the DISA or
Automated Attendant caller dials
incorrectly or waits too long to dial.
The call can either disconnect (0) or
Transfer to an alternate destination
(a ring group, In-Skin/External,
Centralized). When setting the DISA
and DID Operating Mode, you make
an entry for each Night Service
mode.
UNIVERGE SV8100
Assigned Data
0 (No Setting)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or VM8000
InMail)
(default = 1)
0~20
(0 = No Setting)
(default = 1)
0 = Extension Number
Service Code Specify
(Intercom)
1 = Use Dial Conversion
Table
(default = 0)
0 = Normal
1 = Alarm
(default = 0)
0 = No Message
1 = 01~100 (VRS
Messages)
2 = 01~4 (ACI Group
Number)
3 = 01~64 (Extension
Group Number)
(default = 0)
(Mode 1~8) All Trunks =
Ring Group 1
Direct Inward Dialing (DID)
Level
1 2 3