Single Line Telephones - NEC Univerge SV8100 Features And Specifications Manual

UNIVERGE SV8100
Description
The system is compatible with 500 type (Dial Pulse) and 2500 type (DTMF) analog single line telephones
(SLTs). You can install single line telephones as On-Premise or Off-Premise extensions. Single line
telephone users can dial codes to access many of the features available to multiline terminal users. With
single line telephones, you can have your system simulate PBX type operation.
There are 320 single line telephones available (note that this number may be restricted due to system
power requirements).
When installing single line telephones you must have:
A port on an LCA blade for each single line telephone installed.
If you have 2500 sets, at least one block reserved on the CD-CP00-AU for analog extension DTMF
reception.
DTMF Dial Out Timer Added
A program is added for DTMF dialing, Program 20-03-07 : System Options for Single Line
Telephones Trunk Call Dial Forced Sending Start Time (Forced Dial). When Program 20-03-03 : System
-
Options for Single Line Telephones – SLT DTMF Dial to Trunk Lines is set to 0 (receive all digits before
sending), the system follows the timers in Program 20-03-04 and Program 20-03-07.
The timer in Program 20-03-04 System Options for Single Line Telephones – Dial Sending Start Time for
SLT or ARS resets when the user dials another digit.
The timer in Program 20-03-07 System Options for Single Line Telephones – Trunk Call Dial Forced
Sending Start Time (Forced Dial) does not reset when a digit is dialed. The user must finish dialing all the
digits before this timer expires (entries: 0~64800 seconds, default: 0).
Conditions
Dial Pulse (500 type) single line telephones cannot access any features that require the user
to dial
#
A single line telephone connectred to an APR adapter canot place a call on hold by pressing
the Flash key.
A single line telephone can initiate an Internal Zone page, but cannot receive an Internal
Zone Page.
When a Ring Group call rings a single line station, the BLF indication shows busy.
Stutter Dial Tone is supported to Single Line Telephones for Voice Mail Message Waiting.
SV8100 Features and Specifications Manual
or .

Single Line Telephones

Issue 1.0
2 - 933