NEC Univerge SV8100 Features And Specifications Manual page 765

UNIVERGE SV8100
Program
Program Name
Number
20-09-02 Class of Service (Incoming Call
Service) – Caller ID Display
22-11-01 DID Translation Number
Conversion – Received Number
22-11-02 DID Translation Number
Conversion – Target Number
80-01-01 Service Tone Setup – Tone 44,
External Dial Tone
80-01-01 Service Tone Setup – Tone 57,
Off-Hook Beep Tone - Headset
Earpiece ringing Tone
80-03-01 DTMF Tone Receiver Setup –
Detect Level
SV8100 Features and Specifications Manual
Description/Comments
Turns Off (0) or On (1) the Caller
ID display at an extension.
Define the digits received by the
system for the telephone number
on which a Mobile Extension user
calls into the system.
For the DID number defined in
Program 22-11-01, enter the
extension number for the Mobile
Extension user.
It is necessary to adjust the DID/
DISA dial tone (tone 44) to a
Repeat Count of 250 (by default,
this is set to 0). The system must
be reset for this change to take
affect.
If required, use this option to
change the tone heard when a
Mobile Extension user goes off
hook to answer a call prior to
pressing *. The system must be
reset for this change to take affect.
Select the Detect Level to be used
for DTMF Tone detection. For the
extension DTMF, this entry must
allow for a detection of -25dBm.
Set the minimum detection level in
Program 80-03-03. The system
must be reset for this change to
take affect.
Assigned Data
0 = Off
1 = On
(default = 1 for
COS 1~15)
Maximum eight digits
(default not assigned)
Maximum 24 digits
(default not assigned)
0~255 (0 = until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
0~255 (default 0 = until
On-Hook)
Refer to Table 2-14
Service Tone Setup,
Program 80-01-01 on
page 2-555
0 = 0dBm ~ -25dBm
1 = -5dBm ~ -30dBm
2 = -10dBm ~ -35dBm
3 = -15dBm ~ -40dBm
4 = -20dBm ~ -45dBm
5 = -25dBm ~ -50dBm
6 = -30dBm ~ -55dBm
default: Type 1~5 = 0
Issue 1.0
Level
1 2 3
2 - 741