NEC Univerge SV8100 Features And Specifications Manual page 402

Issue 1.0
Level 3 – these programs are not often assigned and require an expert level working knowledge of
the system to be properly assigned.
Program
Program Name
Number
10-03-01 ETU Setup
10-09-01 DTMF and Dial Tone Circuit
Setup
14-05-01 Trunk Group – Trunk group
Number
15-07-01 Programmable Function Keys
20-06-01 Class of Service for
Extensions
2 - 378
Description/Comments
Use program 10-03-XX to setup and
confirm the basic configuration data
for each blade. This program
represents different data depending
on the blade installed in the slot.
Please refer the SV8100
Programming Manual for a more
detailed description of this program.
If the system has DTMF DID trunks,
be sure to reserve at least one circuit
for analog trunk DTMF reception
(type 0 or 2). There must be an
available receiver for each DTMF
DID trunk.
Use the following as a guide when
allocating DTMF receivers:
In light traffic sites, allocate one
DTMF receiver for every 10 devices
that use them.
In heavy traffic sites, allocate one
DTMF receiver for every five devices
that use them.
Put DID trunks in the same trunk
group (other than group 1). If you
have several types of DID trunks, put
each type in a separate trunk group.
You can assign line or Call
Appearance (CAP) Keys for DID
trunks (Trunks: 1~200).
Assign a Class of Service (1~15) to
an extension.
UNIVERGE SV8100
Assigned Data
The assigned data varies
depending on the blade
installed in the slot.
Please refer to the
SV8100 Programming
Manual for a more
detailed description of
the 10-03-XX programs.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource 01~08
= 1 (Extensions)
Circuit/Resource 09~32
= 2 (Trunks)
Circuit/Resource 33~96
= 0 (Not Used)
Circuit/Resource 97~160
= 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available.
Trunks 1-200
Trunk Group 1-100
Priority 1-200
Default = All trunks in
Trunk Group 1 with
priority in trunk order.
Trunk 1 priority = 1 Trunk
200 priority = 200.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
00 ~ 99 (Appearance
Function Code) (Service
Code 752 by default)
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port =
Class 1
Direct Inward Dialing (DID)
Level
1 2 3