NEC Univerge SV8100 Features And Specifications Manual page 231

UNIVERGE SV8100
An additional digit (such as 1) may be required to complete the call (Program 10-02-04).
For example:
Incoming Caller ID shows: 2125551212.
If your area code is NOT 212, define a 1 in Program 10-02-04. When callback is executed, the
system prefixes 1 on the digits dialed string.
Caller ID Sender Queuing Added
The UNIVERGE SV8100 system can provide Caller ID (calling party number) to a single line telephone
with a display.
The system can queue incoming calls to the single line telephone if the system Caller ID sender resources
are busy. Refer to Program 20-19-05 in the UNIVERGE SV8100 Programming Manual.
If the single line telephone user lifts their handset while an incoming call is waiting in queue, they hear
silence (no dial tone) and cannot dial out. When the single line telephone user goes back on-hook, the
system immediately sends the queued call to the single line telephone without Caller ID.
Option Available for FSK or DTMF Type for Single Line Telephone
An option (Program 15-03-11) is available for the Caller ID which allows you to select either FSK or DTMF
as the Caller ID type to be received by a single line telephone.
Option Available for FSK or DTMF Type from Analog Trunk
An option (Program 14-02-16) is available for the Caller ID which allows you to select the type of Caller ID
signal from an analog trunk – FSK or DTMF.
Conditions
To have pre-answer Caller ID from the voice mail, the call must be an unscreened transfer.
Caller ID is provided by the CD-CP00-AU. The PZ-BS10 blade, which plugs into the chassis,
can provide additional resources for Caller ID if needed.
Caller ID Name can display up to 12 characters.
Caller ID Number can display up to 11 characters.
A Caller ID Number with more than 12 digits follows Program 20-19-01 (first 10 or the last 10
digits).
Caller ID information can be stored in Speed Dialing or One-Touch bins.
Caller ID can be displayed for incoming calls and transferred calls.
ARS can block outgoing Caller ID information all-by-call. To do this, insert the Caller ID block
code (e.g., .67) in the ARS Dial Treatments.
Trunks with Privacy Release enabled display Caller ID until the call is answered. To view it
after the call has been picked up, press the line key, which sets the call to private mode. To
keep the call on Privacy Release, press the Help + Exit keys.
SV8100 Features and Specifications Manual
Issue 1.0
2 - 207