NEC Univerge SV8100 Features And Specifications Manual page 705

UNIVERGE SV8100
A Mesh topology network is not supported.
K-CCIS requires assigning a point code for each office. Point codes differentiate between an
originating office and a destination office in the K-CCIS Network. Assigning point codes
requires the following considerations:
The point code must be unique in the network.
When a system has two or more CCH channels, the same originating point code must
be assigned to all channels in the system.
The UNIVERGE SV8100 can have a maximum of 255 codes assigned to distant
systems.
Using an UNIVERGE SV8100-to-UNIVERGE SV8100 network, centralized voice mail is not
supported when an Open Numbering Plan is used.
Centralized E911 – K-CCIS is supported (US Only).
When Centralized E911 – K-CCIS is not used, each UNIVERGE SV8100 system in a
K-CCIS network must have at least one trunk for Emergency 911 calls (US Only).
Using a NEAX-to-UNIVERGE SV8100 network, the PBX must supply centralized voice mail.
Multiline terminals must have an available Call Appearance (CAP) key to originate or answer
a K-CCIS trunk call.
Direct access of K-CCIS voice or data channels using Line keys or Specified Line Seizure
access codes is prohibited.
The Recall key or Drop key does not function on K-CCIS calls. When either key is pressed,
operation is ignored, and the call continues.
Trunk queuing is prohibited on a K-CCIS trunk route.
The ability to route an incoming DID call directly across a K-CCIS link (Direct Inward
Dialing
-
This feature is not supported by the CD-4ODTA Analog Line interface.
Up to four CD-CCTA blades can be assigned per system.
Extension numbers cannot start with 0 or 9.
Internal Calls, transferred calls, and K-CCIS calls do not provide Caller ID to single line
telephones.
Caller ID Call Return feature is not supported with K-CCIS calls.
Call Park Searching is supported only in the local system.
When the system searches the Dial Extension Analyze Table (PRG 11-20-01), the system
uses prefix searching, giving the lower table number the higher priority. For example, the
user programs 211 in table 1 and 2113 in table 2, then dials 2113, the system selects table 1.
When using ARS Class of Service Matching, CCIS calls will always follow Class of Service 1.
SV8100 Features and Specifications Manual
K-CCIS) is supported only when a Closed Numbering Plan using F-Routes is used.
Issue 1.0
2 - 681