Table 5-67. 3 Winding Primary Settings Block - ABB TPU2000 Technical Manual

TPU2000/2000R Modbus/Modbus Plus/ Modbus TCP/IP Automation Guide
Register
Address
If the Alternate Settings 1 command is selected (as per Section 5 in this document), the settings are configured as
follows in Table 5-67).

Table 5-67. 3 Winding Primary Settings Block

Register
Address
63200 SPARE_1
63201 Execute Register
0 = No Action
1 = Update Registers
2 = Refresh Registers
63202 Access Password
63203 Access Password
63204 SPARE_2
63205 87T-3 Amp
63206 51P-3 Curve Select (TYPE I )
63207 51P-3 Pickup Amps
63208 51P-3 Time Dial/Time Delay
63209 50P-3 Curve Select Byte (TYPE II)
63210 50P-3 Pickup Amps
63211 50P-3 Time Dial/Time Delay
Item
Bit 0: Neutral Tap Range Wdg1 (lsb)
Bit 1: Neutral Tap Range Wdg1
Bit 2: Neutral Tap Range Wdg1
Bit 3: Neutral Tap Range Wdg1
Bit 4: User Definable Curves
Bit 5: Reserved
Bit 6: Neutral Tap Range Wdg 3
Bit 7: Phase Tap Range Wdg3
Bit 8: MOCT's on Wdg1
Bit 9: MOCT's on Wdg1
Bit 10: Reserved
Bit 11: Reserved
Bit 12: Reserved
Bit 13: Reserved
Bit 14: Reserved
Bit 15: Reserved (msb) (leftmost bit)
Item
U
U
ASCII – 2 Characters Leftmost Digits
ASCII – 2 Characters Rightmost Digits
Unsigned Integer 16 Bits
2<=Range<=9 (X10)
0.4<=Range<=1.8 (X50)
Unsigned 16 Bits
Range 0-12 (See Text Above)
Unsigned 16 Bits
1<=Range<= 12 *10
0.2<=Range<=2.4 Amp * 50 (See Note)
Unsigned 16 Bits
1<=Range <=10 (X20) Time Dial
0<=Range<=10 (X20) Time Delay
Unsigned Integer 16 bits
0<=Range<=12 (See Text Above)
Unsigned 16 Bits
0.5<=Range<= 20 *10
Unsigned 16 Bits
Description
(0 = 1-12 A, 1 = 0.2-2.4A)
(0 = 1-12 A, 1 = 0.2-2.4A)
(0 = 1-12 A, 1 = 0.2-2.4A)
(0 = 1-12 A, 1 = 0.2-2.4A)
(0 = 1-12 A, 1 = 0.2-2.4A)
(0 = 1-12 A, 1 = 0.2-2.4A)
(1= None 0= MOCT Present)
(1= None 0= MOCT Present)
Description
n s i g n e d 1 6 B i t s
n s i g n e d 1 6 B i t s
196