ABB TPU2000 Technical Manual page 271

3
3
3
3
3
3
0 Transmit Status "N" Commands ( 3 0 n )
N
0
1
2
3
4
5
6
7
0.0 Transmit Fast Status ( 3 0 0 )
This command will cause the relay to respond with one data message with the format shown below:
byte 3
ST2 ST1 L T4 T3 T2 T1 T0 | P5 P4 P3 P2 P1 P0 A3 A2 | A1 A0 D5 D4 D3 D2 D1 D0
D5 D4 D3 D2 D1 D0 => Division Code . RTD division code is 5(000101)
A3 A2 A1 A0 => A0 - One/More Unreported Operations
A1 - Reserved
A2,A3 - Reserved
P5 P4 P3 P2 P1 P0 => Product ID. (TPU2000 = 010011)
T2 T1 T0 => Reserved
T4 T3 => Reserved
L => Reserved for local operator interface action.
ST2 ST1 => Reserved for corporate standard status bits.
0.2 Unit Information ( 3 0 2 )
This command will cause the relay to transmit data messages containing catalog number and the software version.
1/1-5/3
6/1
6/2
6/3
7/1
7/2
7/3
8/1
8/2
8/3
0.3 RCVDALL ( 3 0 3 )
- Reserved -
TPU2000/2000R Modbus/Modbus Plus Automation Guide
10 n
11 n
12 n
13 n
14 n
15 n
Definition
Transmit Fast Status
Reserved
Unit Information
Reserved
Unreported Record Status
Reset Alarms/Target LEDs
Reset Max/Min Demand Currents
Show Logical I/O status
|
Catalog Number (18 characters)
CPU Software Version high byte (*100)
CPU Software Version low byte
DSP Software Version (*10)
Front Panel Software Version (*10)
Rear Communication Software version (*10)
Serial Number most significant low byte
Serial Number least significant high byte
Serial Number least significant low byte
Serial Number most significant high byte
Receive Edit Buffer Commands
Receive Edit Buffer Commands
Programmable Curve Commands
Waveform Capture Commands
Reserved for Factory
byte 2 | byte 1
261