Komatsu PC200-8M0 Shop Manual page 1122

SEN06148-01
Special tools
Part number
2 793-498-1210 Lifter (Suction cup)
X
3 20Y-54-13180 Stopper rubber
Removal
a Remove the window glass to be replaced
according to the following procedure.
1. Using seal cutter [1], cut the adhesive between
broken window glass (7) and operator's cab
(metal sheet)(8).
a If a seal cutter is not available, make holes
on the adhesive and dam rubber with a
drill and pass a fine wire (piano wire, etc.)
[2] through the holes. Then, grip the both
ends of the wire with pliers [3], etc. (or
hold them by winding them onto some-
thing) and move the wire to the right and
left to cut the adhesive and dam rubber.
Since the wire may be broken by the fric-
tional heat, apply lubricant to the wire.
6
50-700
Part name
t 2
t 2
Removal and installation of operator cab glass (stuck
(The figure shows the operator's cab of a wheel
loader.)
a If the window glass is broken finely, it may
be removed with a knife [4] and a screw-
driver.
a Widening the cut with a flat blade screw-
driver, cut the dam rubber and adhesive
with knife [4].
(The figure shows the operator's cab of a wheel
loader.)
2. Remove the window glass.
PC200, 200LC, 220, 220LC-8M0
700 Cab and its attachments