Komatsu PC200-8M0 Shop Manual page 967

200 Engine and cooling system
Removal and installation of fuel supply pump assembly
[*5]
q How to install the gear (19)
a The shaft (21) and gear (19) mating face must
be clean (without dirt or foreign material) and
dry prior to assembly.
1. Install the gear (19) onto the shaft (21).
2. Install the lock washer (20) and nut (18) and
finger tighten.
3. Use the support A12 and 1/2 inch spinner han-
dle [1] to hold the gear in place while tightening
the nut (18).
3
Mounting nut of fuel supply pump gear:
105 ± 5 Nm {10.7 ± 0.51 kgm}
Air bleeding
q
Bleed air from the fuel injection system.
a Refer to the "Testing and adjusting" chapter.
PC200, 200LC, 220, 220LC-8M0
SEN06143-00
5
50-200