200 Engine and cooling system
Removal and installation of engine and hydraulic pump assembly
8.
Disconnect pre-cleaner (6), pre-cleaner base
pipe (7). (If equipped)
9.
Remove covers (8) and (9).
10. Disconnect hose (10a).
11. Remove cover (10).
12. Remove frame (11).
13. Remove cover (12).
14. Remove frame (13).
15. Remove covers (14) and (15).
a Cover (15) cannot be removed unless
removing cover (9).
PC200, 200LC, 220, 220LC-8M0
a The hatched area is made of rubber
(lower side).
16. Remove mounting bolt (16).
17. Remove mounting bolt (17).
18. Remove covers (18) and (19).
19. Remove frame (20).
20. Remove cover (21).
21. Remove frame (22) between the control valve
and the engine.
a Cover (24) can be removed after removing
frame (22).
22. Remove mounting bolt (23) and remove cover
(24) upwards.
a As cover (24) is just stuck, there is no
need to remove the lower bolt.
SEN06143-00
45
50-200