700 Cab and its attachments
Removal and installation of operator cab glass (stuck
4.
Stick
dam
rubber
tape)(6) along the inside edge of the glass
sticking section.
a Do not remove the release tape of dam
rubber on the glass sticking side before
sticking the glass.
a When sticking the dam rubber, do not
touch the cleaned surface to the utmost.
a Care should be taken not to float the dam
rubber of each sticking corner.
a When sticking dam rubber (6) around a
frame, do not lap its finishing end over the
starting end. Or, make clearance of about
5 mm between them (e).
1)
Stick dam rubber (6) for right side window
glass (1) to the position as shown in the
figure.
a Stick dam rubber (6a) additionally to
right side window glass (1).
q
Positions to stick additional dam rub-
ber to the right side window glass:
(f): 50 mm
(g): 90 mm
(h): 250 mm
PC200, 200LC, 220, 220LC-8M0
(both-sided
adhesive
2)
Stick dam rubber (6) for left side window
glass (2) to the position as shown in the
figure.
SEN06148-01
9
50-700