SEN06143-00
3
Engine mounting bolt (4 points):
245 – 308.9 Nm {25 – 31.5 kgm}
a The nut is not welded except at the engine
ground point. Due to that reason firstly fix nut
locking tool (plate) A8 with bolt (B) to restrict nut
(N) from turning, then remove engine mounting
bolt (82).
a Reference
3
Engine mounting bracket (4 points) bolts (B):
122.5 – 147 Nm {12.5 – 15 kgm}
a Reference
Overview of the depth of the insertion of the air
hoses and radiator hoses.
52
50-200
Removal and installation of engine and hydraulic pump as-
q
Refilling engine coolant
Refill coolant through the coolant filler port up
to the specified level. Start the engine and cir-
culate the coolant, and then check the coolant
level.
5
Coolant: 20.3 l (PC200/200LC-8M0)
q
Refilling with oil (hydraulic tank)
Refill hydraulic oil through the oil filler port to
the specified level. Let the oil circulate in the
hydraulic system by starting the engine. Then
check the oil level again.
5
Hydraulic tank:
3
Hydraulic tank drain plug:
Air bleeding
q
Bleed the air from the circuit between the valve
and the hydraulic cylinder. For details, see
Testing and adjusting, "Bleeding air from each
part".
200 Engine and cooling system
19.9 l (PC220/220LC-8M0)
237 l (PC200/200LC-8M0)
244 l (PC220/220LC-8M0)
58.8 – 78.5 Nm {6.0 – 8.0 kgm}
PC200, 200LC, 220, 220LC-8M0