Komatsu PC200-8M0 Shop Manual page 999

200 Engine and cooling system
Removal and installation of radiator assembly
11. Remove the mounting bolts (10) and lift out
radiator assembly (9).
4
Radiator assembly: 15 kg
PC200, 200LC, 220, 220LC-8M0
Installation
[*3]
q Installation is done in the reverse order of
removal.
[*1], [*2]
a Align the hose to the original position (marking
position).
a Align the clamp to the original position.
a Reference
Inserted air hose length
q 45 mm (Radiator side)
q 40 mm (Engine side)
3
Radiator hose clamp:
[*3]
a Confirm that the heat insulating seal material
(sponge) of the radiator peripheral part is not
damaged. If the heat insulating seal material
(sponge) is damaged, replace it to the new
one.
Confirm from the under cover side that convex-
ity (A) of the radiator is correctly set to concav-
ity (B).
q Refilling engine coolant
Refill coolant through the coolant filler port up
to the specified level. Start the engine and cir-
culate the coolant, and then check the coolant
level.
5
Coolant: 20.3 l (PC200/200LC-8M0)
SEN06143-00
10.8 – 11.8 Nm {1.1 – 1.2 kgm}
19.9 l (PC220/220LC-8M0)
50-200
37