Komatsu PC200-8M0 Shop Manual page 1037

300 Power train
Disassembly and assembly of final drive assembly
14. Washer
Install washer (2).
a After installing washer (2), measure
dimension (i) from the upper end face of
No. 1 planetary gear (8) to that of ring
gear (12) to check for the correct assem-
bly condition.
a If dimension (i) does not fall within 2.11 ±
0.97 mm, the assembly is built incorrectly.
Recheck.
PC200, 200LC, 220, 220LC-8M0
15. Cover
1) Using eyebolts [1], install cover (1).
4
Cover: 25 kg
2
Mating faces of cover and ring gear:
a Do not apply liquid gasket (LG-6) to tap.
2) Using tool J7, install the 20 mounting
bolts.
3
Mounting bolt
1st time: 98 Nm {10 kgm}
2nd time:
80 to 90 deg. (rotating angle)
16. Refilling of oil
Tighten drain plug and supply power train oil
(TO30) from the oil filler port.
5
Final drive case: 5.4 l
a Do a final check of the oil level at the
determined position after installing the
final drive assembly to the chassis.
SEN06144-00
Liquid gasket (LG-6)
21
50-300