Komatsu PC200-8M0 Shop Manual page 1046

SEN06144-00
6. No.2 carrier assembly
1) Assemble No.2 carrier assembly as fol-
lows.
a Since there is a mark to be caulked in
the side hole (h) of carrier (18) at the
time of pin insertion, remove protru-
sion for hole inner diameter before-
hand.
(Refer to 5])
1] Incorporate plate (22) into carrier
(18).
2] Incorporate bearing (21) and 2 pcs. of
upper and lower thrust washer (19)
into gear (20).
3] Set gear assembly into carrier (18).
a PC200-8M0, PC200LC-8M0
a PC220-8M0, PC220LC-8M0
30
50-300
Disassembly and assembly of swing motor and swing ma-
4] Strike lightly with plastic hammer,
etc., align pin hole location of shaft
(17) and carrier and install shaft (17).
a Install the shaft, rotating the plan-
5] Insert pin (16),
a As inserting the pin, install not to
a After inserting the pin, caulk 2
2) Install No.2 carrier assembly (15) with bolt
(14).
2
Mounting bolt threaded section:
3
Mounting bolts:
3) Install O-ring (36) into case (30).
300 Power train
etary gear. Take care so the
thrust washer is not damaged.
interfere claw section ((a) sec-
tion) which is in 3 places on cir-
cumference into carrier thin part
((b) section).
However, actual thing may have
the thin section on the other side.
So make sure to confirm the
actual thing and assemble not to
interfere claw section of the pin
into the thin part.
parts of the carrier (c) around the
pin hole.
Adhesive compound (LT-2)
157 – 196 Nm {16 – 20 kgm}
PC200, 200LC, 220, 220LC-8M0