D-Sub 25-Pin Connector - Kenwood NX-5000 Series Common Function Reference

11 EXTERNAL PORTS

11.2 D-sub 25-pin Connector

11.2 D-sub 25-pin Connector
Supported Models: Mobile
For Mobile, the transceiver is equipped with function ports (AUX Input/ AUX Output) that can be programmed for use with
the D-sub 25-pin connector located on the rear panel of the transceiver.
Available Functions for AUX Input Ports
This section describes each function that can be assigned to AUX Input ports.
Depending on a function assigned to an AUX Input port, the function immediately functions if the AUX Input port is active
when the transceiver is turned ON. In addition, depending on the function assigned to an AUX Input port, the function does
not function when the transceiver is in the Radio Inhibit state. Refer to the following table for how the function functions
depending on the transceiver status.
Table 11-3 Behavior of Each Function Depending on the Transceiver Status
Function
External PTT (Voice)
External PTT (Data)
Data PTT
External PTT (PA)
Channel Select A to Channel Select D
DTC
Speaker Mute
Mic Mute
External Monitor
External Hook
External Speaker
Emergency
AUX Input Status Message 1 to AUX Input
Status Message 3
Scan
Call 1 to Call 6
Light Sense
Zeroize
Scrambler/ Encryption
*1 The function functions when the Stun or Radio Inhibit state is reset.
Yes: functions, No: does not function
Configuration using KPG-D1/ D1N
Assigning functions to the AUX Input port (
Common FUNC (K, F)/Ver 2.20
When the transceiver While the transceiver
is turned ON is in the Stun state
No
No
No
No
Yes
Yes
Yes
Yes
Yes
Yes
Yes
Yes
No
Yes
No
Yes
Yes
Yes
Transceiver Settings > Extended Function > AUX)
Transceiver Status
While the transceiver is
in the Radio Inhibit state
No
No
No
No
*1
*1
Yes
Yes
Yes
Yes
Yes
No
No
*1
No
Yes
No
*1
CONTENTS
No
No
No
No
*1
*1
*1
*1
*1
*1
*1
No
No
*1
No
*1
No
*1
211
INDEX