Kenwood NX-5000 Series Common Function Reference page 366

STRUCTURING A MULTI RF DECK/ MULTI
17
17 STRUCTURING A MULTI RF DECK/ MULTI CONTROL HEAD
CONTROL HEAD
Supported Models: Mobile
This chapter describes the steps to structure a Multi RF Deck/ Multi Control Head system by connecting 1 or 2 Control
Heads to multiple RF Decks.
Also refer to "Configuring the Initial
when structuring a Multi RF Deck/ Multi Control Head system.
17.1 Initial Configuration for Multi RF Deck/ Multi Control Head
To activate Multi RF Deck/ Multi Control Head, the firmware needs to be updated to version 1.62.00 or later. To activate
Multi RF Deck/ Multi Control Head properly, the RF Deck firmware and the Control Head firmware must be the same.
Because of the structure of the transceiver, the firmware of each RF Deck needs to be updated individually in a Single RF
Deck / Single Control Head structure.
Assemble each of the following devices before updating the firmware:
0 Attach KRK-15BM to the RF Deck.
0
Attach KRK-14HM to KCH-19M.
Note
If KCH-20RM is used, KRK-14HM does not need to be attached to KCH-20RM.
Attaching KRK-15BM to the RF Deck
If KCH-19M is attached to the RF Deck, KCH-19M needs to be removed from the RF Deck by referring to step 1 to step 3
below.
If no device is attached to the RF Deck, attach KRK-15BM to the RF Deck by referring to step 4 and later.
1
Lift up 2 tabs of KCH-19M on the bottom of the RF Deck by using a flathead screwdriver, and remove
KCH-19M from the chassis.
Common FUNC (K, F)/Ver 2.20
Configuration" in "Multi RF Deck/ Multi Control Head" for the related configuration of
Figure 17-1 Removal of the Panel
CONTENTS INDEX
335