Kenwood NX-5000 Series Common Function Reference page 448

19 CONFIGURATION FOR EACH FUNCTION
19.3 Available Functions for the Selector
Available Functions for the Lever Switch
Supported Models: Portable
The following are the functions that can be assigned to the Lever switch.
Positioning the Lever switch to the [A] or [B] position activates the assigned function.
Function Name
None No function is activated.
Alternates the status of the AUX Output port. The AUX Output port
status is changed to inactive if the status is active; or, the AUX
Output port status is changed to active if the status is inactive. The
AUX
status of the AUX port is changed by operating the Lever switch,
and an external device connected to the AUX port can be
controlled.
Toggles between the Channel Name display and the Zone-channel
Display Format
display.
Waits for the activation of the Key Function assigned to the 2nd
Function and starts counting down the Mode Reset Timer. The
Function
Function status will be reset if no key is pressed before the amount
of time configured in Mode Reset Timer elapses.
Enters GPS Position Display Mode.
GPS Position Display See
GPS POSITION DISPLAY
Analog Conventional/ P25 Conventional/ NXDN Conventional:
Selecting a channel where "Medium" or "Low" is configured for the
transmission power, and then positioning the Lever switch to the
position assigned "High Transmit Power" switches the transmission
power to "High".
P25 Trunking/ NXDN Trunking:
High Transmit Power
Selecting a channel in a system where "Medium", "Low" or "Auto"
is configured for the transmission power and then positioning the
Lever switch to the position assigned "High Transmit Power"
switches the transmission power to "High".
See
Transmit Power
Toggles the Key Lock between enabled and disabled.
Key Lock See
Locking the Transceiver Keys (Key Lock)
Toggles the Lone Worker between enabled and disabled.
See
0
Lone Worker
0
Common FUNC (K, F)/Ver 2.20
Table 19-6 Available Functions for the Lever Switch
Description
P25 FUNC Placing the Transceiver in Emergency Mode Using
the Lone Worker Function
NXDN FUNC Placing the Transceiver in Emergency Mode Using
the Lone Worker Function
Available Communication
Systems
-
ALL
ALL
ALL
ALL
ALL
ALL
ALL
CONTENTS INDEX
*1
417