Relaying The Received Signal (Mobile Relay Station) - Kenwood NX-5000 Series Common Function Reference

16 MULTI RF DECK/ MULTI CONTROL HEAD

16.18 Relaying the Received Signal (Mobile Relay Station)

16.18 Relaying the Received Signal (Mobile Relay Station)
Mobile Relay Station is the function to relay the received signal by 2 RF Decks in a Multi RF Deck structure.
If this function is used, as shown in the diagram below, if RF Deck 1 transfers the signal received from Transceiver A to RF
Deck 2, the signal can be transferred from RF Deck 2 to Transceiver B.
Subscriber Unit A
To use this function, the following configurations and RF Deck connections are required:
0
By using KPG-D1/ D1N, configure the 2 RF Decks that activate Mobile Relay Station, and configure a Mobile Relay
Station Zone-channel for each RF Deck. (Refer to
0
By using KPG-D1/ D1N, assign the functions to enable Mobile Relay Station to the PF key and communication port.
(Refer to Configuring Mobile Relay
0
Connect the 2 RF Decks that activate Mobile Relay Station by a D-sub 25-pin cable. (Refer to
by Using a D-sub 25-pin
Hereinafter, the RF Decks configured with a Mobile Relay Station Zone-channel are referred to as "RF Deck 1" and "RF
Deck 2".
Note
Only a channel in an Analog Conventional system, NXDN Conventional system, or P25 Conventional system can be
0
configured as a Mobile Relay Station channel. However, a channel with "Mixed" configured in Channel Type cannot be
configured as a Mobile Relay Station channel.
The configurations of the following need to be the same for each channel configured in the 2 RF Decks that activate
0
Mobile Relay Station.
Channel Type
0
Channel Spacing (for a channel in an Analog Conventional system or NXDN Conventional system only)
0
P25 Modulation Type (for a channel in a P25 Conventional system only)
0
If Mobile Relay Station is used, a delay of up to approximately 1 sec may occur in audio communications from the
0
transceiver.
Configuration using KPG-D1/ D1N
0
Configuring the RF Deck activating the Mobile Relay Station function (RF Deck Data) (
Extended Function > Mobile > Mobile Relay Station > Mobile Relay Channel List)
0
Configuring the Mobile Relay Station Zone-channel (
Mobile Relay Station > Mobile Relay Channel List)
Common FUNC (K, F)/Ver 2.20
RF Deck 1
KRK-15B
Control
Head 1
Figure 16-80 Outline of Mobile Relay Station
Configuring Mobile Relay
Station.)
Cable.)
RF Deck 2
KRK-15B
Station.)
Transceiver Settings > Extended Function > Mobile >
CONTENTS
Subscriber Unit B
Connecting the RF Deck
Transceiver Settings >
322
INDEX