Which Parameters Are Restored To Default Values After Default Settings Are Operated; Exporting Data - Huawei NetCol8000-E220 User Manual

Modular indirect evaporative cooling system
Hide thumbs Also See for NetCol8000-E220:
Table of Contents

Advertisement

NetCol8000-E220 Modular Indirect Evaporative Cooling
System
User Manual
Step 4 Choose Maint > Diagnostic Mode > Exit or tap
----End
7.1.16 Which Parameters Are Restored to Default Values After
Default Settings Are Operated
After choosing Settings > Restore Defaults > Comfirm, the following parameters are
displayed:
To prevent key data from being lost, you are recommended to record all parameter values or
back up data with export configurations before restoring defaults. Then change the parameter
values back to the recorded values after restoring defaults.

7.1.17 Exporting Data

Context
With the one-click mode, you can export active alarms, historical alarms, run logs, and so on.
You are advised to use the FAT32 USB flash drive with a capacity no greater than 64 GB.
Format the non-FAT32 USB flash drives into FAT32 ones before using them.
Before using a USB flash drive, ensure that its data has been scanned by antivirus software
and is secure.
Issue 02 (2019-10-10)
All parameters displayed on Settings > System Settings.
All parameters displayed on Settings > Alarm Settings.
All parameters displayed on Settings > Comm Settings.
All parameters except for language and time settings displayed on Settings > Quick
Settings.
Date format and time zone settings displayed on Settings > User Settings.
All parameters displayed on Maint > Sensor Calibration.
After default settings are restored, all communication addresses are changed to 1 and the communication
between all devices and the EMS is disconnected. The communication addresses must be reset to
recover the communication.
Before exporting active alarms, historical alarms, logs, and configurations, ensure that the USB flash
drive has been successfully identified.
If the USB flash drive has been successfully identified,
Copyright © Huawei Technologies Co., Ltd.
to exit the diagnostic mode.
is displayed in the status bar.
7 FAQ
185

Advertisement

Table of Contents
loading

Table of Contents