Huawei NetCol8000-E220 User Manual page 70

NetCol8000-E220 Modular Indirect Evaporative Cooling
System
User Manual
Figure 3-48 Removing the transport fasteners from the compressor


Step 2 Remove the transport fasteners.
Step 3 Tighten the bolts on the compressor again to a torque of 12 N.m.
Step 4 Take out the two desiccant bags from No. 2nd maintenance door.
Step 5 Open the No. 1st maintenance door, and take out the one desiccant bags from No. 1st
maintenance door.
Step 6 Remove the air filter from the fresh air vent on the outdoor side and take out two desiccant
bags from the device.
Figure 3-49 Position of the desiccants
Issue 02 (2019-10-10)
Do not remove the bolts directly.
Put away the removed transport fasteners so that you can reinstall them if the indoor unit is to be
transported again in the container scenario.
Copyright © Huawei Technologies Co., Ltd.
3 Installation Guide
62