Huawei NetCol8000-E220 User Manual page 95

NetCol8000-E220 Modular Indirect Evaporative Cooling
System
User Manual
Parameter
Smart
cooling
product
address
Enable
Teamwork
CAN
resistor
Teamwork
function
Networking
mode
Number of
smart
cooling
products in
this group
Number of
running
smart
Issue 02 (2019-10-10)
Description
which is the same for all the
devices in the group.
Smart cooling product
addresses should be
different from each other.
Indicates the build-out
resistor status of each smart
cooling product in a
teamwork group. Set the
parameter if CAN network
is used.
Disable or enable the
teamwork function. If the
teamwork function is
disabled, this device is
operating according to its
own control. If the
teamwork function is
enabled, this device works
in harmony with others that
in the same group.
Networking mode for the
teamwork. The networking
mode set on the screen must
be consistent with the actual
networking mode.
Otherwise, the teamwork
control function will be
unavailable. If the
networking mode changes,
select the corresponding
networking mode on the
screen.
Number of the smart
cooling products in this
group (1 to 32 can be set).
Number of active units in a
group. The value ranges
from 1 to Number of smart
Copyright © Huawei Technologies Co., Ltd.
4 Power-on and Commissioning
Configuration
Principle
Set the assigned unit
address.
 Set this parameter to
No for non-teamwork
scenarios.
 For teamwork
scenarios, set this
parameter to Yes for
the first and last smart
cooling products in a
teamwork group, and
set it to No for other
smart cooling
products.
Set this parameter based
on the onsite device heat
distribution.
Networked over CAN or
MAC_CAN. CAN
network indicates
teamwork control over a
CAN bus, MAC_CAN
network teamwork
control over an FE port.
Total number of the smart
cooling products in this
group.
The host allocates running
units by smart cooling
product unit address in
Default Value
NA
No
Disable
CAN network
3
2
87