Operation For Returning To One-To-One Connection; Procedure For Returning To One-To-One Connection - Mitsubishi Electric MELSEC Q Series User Manual

5 CONNECTING WEB SERVER MODULE TO NETWORK

5.3 Operation for Returning to One-to-one Connection

5.3.1 Procedure for returning to one-to-one connection

Make the default operation setting in the switch setting
of GX Developer.
Connect the Web server module to the personal
computer with a crossing cable.
On the following screens from the Administrative menu,
make network setting of the Web server module.
System setting
Dial-up setting
Reset the default operation setting in the switch
setting of GX Developer.
Power the programmable controller OFF and connect
the Web server module according to the network setting.
5 - 13
This section explains the operation for returning to one-to-one connection.
If connection of the Web server module to the network cannot be made or if the
network setting is to be changed, it is required to make one-to-one connection and
perform setting with the Web browser.
POINT
The setting of the Web server module can be changed via the network, however, it
is recommended to set it back to one-to-one connection.
The following is the operating procedure for returning to one-to-one connection.
Start
Completed
(1) Switch setting of GX Developer
Make the default operation setting in the switch setting of GX Developer.
Refer to Section 4.7 for details on the switch setting of GX Developer.
GX Developer
(a) Write "0003
(1) Switch setting of GX Developer
For PC's network setting for one-to-one connection,
refer to Section 4.5.
System setting
Dial-up setting
(2) Reset of switch setting of GX Developer
" to Switch 2 in the switch setting of GX Developer.
H
MELSEC-Q
: Refer to Section 4.6.3
: Refer to Section 4.6.4
5 - 13