Mitsubishi Electric MELSEC Q Series User Manual page 204

5 CONNECTING WEB SERVER MODULE TO NETWORK
Network type setting
IP address setting
Automatic network connection setting at start-up
5
Account setting No. 1
5 - 2
(1) Network setting of Web server module
(a) Make setting to connect the Web server module to the network.
(b) From the Administrative menu, set as follows
(For other than the following settings, the default values will be used.):
[Administrative menu]
(Refer to 2))
1) System setting (Refer to Section 4.6.3)
Item
2) Account setting (Refer to Section 4.6.5)
Item
POINT
After changing the setting, make sure to click on the "Save" button.
The settings are updated when the "Update" button on the Setting update screen is
clicked, the programmable controller is powered off and then on, or the CPU module
is reset. ( )
Note that the setting of the System setting is not updated even if the "Update" button
is clicked.
(2) Network connection of Web server module
(a) Since "Automatic connection to network at start-up." is set in the automatic
network connection setting at start-up on the "System setting" screen, the
Web server module automatically makes network connection at start-up.
(b) Using GX Developer, confirm the following connection status of the Web
server module to the network with input signals of the buffer memory and
the programmable controller CPU.
1) Module READY (X0) is on.
2) Network connection status (X4) is on.
3) IP address and subnet mask storage areas in the network connection
status area
 IP address (buffer memory: 55 to 56)
 Subnet mask (buffer memory: 57 to 58)
"System setting" (Refer to 1))
Select "Connecting through LAN or the router.".
Select "Use the following IP address.".
 IP address
: 192. 168. 10. 3
 Subnet mask
: 255. 255. 255. 0
Select "Automatic connection to network at start-up.".
Enter the following setting for the accounting setting No. 1.
(Delete the default account.)
 User name
: administrator001
 Password
: (example) QJ71WS96ADMIN
 Confirm password : (example) QJ71WS96ADMIN
MELSEC-Q
"Account setting"
Set value
Set value
5 - 2