Mitsubishi Electric MELSEC Q Series User Manual page 510

APPENDICES
Network Different network
communication communication
route
CC IE Control,
NET/10(H)
CC-Link, C24
Ethernet ( 7)
CC IE Field ( 3)
App - 6
QCPU (Q mode)
route ( 6)
( 1)
( 4)
1 As the network number and station No., set the parameter values set for the Q series-
supported E71, QE71, L series-supported E71 or R series-supported E71 on the
access target CPU side.
Also set the "Station No. <-> IP information" parameter of the Q series-supported E71,
QE71, L series-supported E71 or R series-supported E71.
In this case, specify any of "IP address computation system", "Table exchange
system", and "Use-together system" in "Station No. <-> IP information system".
2 Use a CC-Link system master/local module of software version "S" or later on the
access target CPU side.
3 Use the Web server module whose serial No. (first five digits) is 14022 or later.
4 Use the Universal model QCPU whose serial No. (first five digits) is 12012 or later.
5 When the control CPU for the access target network module is a C Controller module,
the Web server module can access the control CPU only.
6 Use a QCPU (Q mode) or RCPU as a control CPU for the access target network
module.
7 To access a programmable controller CPU through Ethernet, use an Ethernet module.
Built-in Ethernet ports of the programmable controller CPU cannot be used.
8 When the access target CPU is Q12DCCPU-V, the access is not possible.
9 Use the Web server module whose serial No. (first five digits) is 16072 or later.
10 When the Network communication route is NET/10(H), the access is not possible.
Access target CPU (PLC series)
RCPU
LCPU QnACPU
( 9)
( 10)
( 1)
( 1)
( 9)
MELSEC-Q
QCPU (A mode), C Controller
ACPU module
( 5)
( 8)
: Accessible : Inaccessible
App - 6