Connecting Web Server Module To Network; Network Connection Through Lan; Access Procedure When Using Static Ip Address - Mitsubishi Electric MELSEC Q Series User Manual

5 CONNECTING WEB SERVER MODULE TO NETWORK

5 CONNECTING WEB SERVER MODULE TO NETWORK
This chapter explains procedures for connecting the Web server module to the network
by LAN/dial-up connection and procedures for connecting and disconnecting it to/from
the network for non-continuous connection.

5.1 Network Connection through LAN

This section explains the case where the Web server module is connected to the LAN-
connected network.

5.1.1 Access procedure when using static IP address

The following shows how to access from the external device to the programmable
controller CPU when a static IP address is assigned to the Web server module.
[System configuration for LAN connection]
Mount the Web server module to slot "0" of the base
unit and power the programmable controller ON.
Connect the Web server module to the personal
computer with a crossing cable.
On the following screens from the Administrative menu,
make network setting of the Web server module.
System setting, Account setting
Power the programmable controller OFF and connect
the Web server module to LAN.
Power the programmable controller ON.
The Web server module is automatically linked to the
network at start-up.
Start a Web browser on the computer and access the
Web server module.
Monitor device data on the "Device monitor" screen.
Completed
5 - 1
GX Developer
Personal computer
IP address :192.168.10.1
Subnet mask :255.255.255.0
Start
Web server module
IP address :192.168.10.3
Subnet mask :255.255.255.0
Ethernet
For PC's network setting for one-to-one connection, refer
to Section 4.5.
(1) Network setting of Web server module
For LAN connection, refer to Section 4.4.1.
(2) Network connection of Web server module
(3) Access to Web server module
For device monitor, refer to Section 6.2.1.
MELSEC-Q
5
5 - 1