Table of Contents
Advertisement
178/233
Bosch Rexroth AG | Electric Drives
Extended Functionality
Channel Selection
Processing an NC Program with the NC Analyzer
Displaying the NC Program:
Rexroth IndraMotion MTX 09VRS | Application Description
and Controls
The F-key <F2> (Channel selection) can be used to switch the channel in the
NC analyzer.
After selecting the program, start the NC analyzer. Breakpoints and variables
that were already set are included in this. The "Program" is activated.
Starting the NC analyzer mode:
The NC program may not be started yet.
Press the F-key <F6> ("NC analyzer step mode") to start the NC analyzer; the
F-key changes to "Restore mode", i.e. the previous operating mode is restored.
For your information, the header of the interface shows the new operating mode
"NC analyzer single step".
Analyzer setting:
●
NC analyzer single step:
Following the start of the NC analyzer, the "NC analyzer single step" op‐
erating mode is active. The program is run step by step, i.e. after each
step, "NC start" needs to be pressed to continue the program.
●
Continue NC analyzer:
Activate the "Program" window. Press the F-key <F5> ("Continue
mode"); the F-key changes to "Step mode".
The program is processed in "sequential block operation" until it meets a
breakpoint, where it stops the program sequence. After the stop, the pro‐
gram can be continued with "NC start" if no error is pending.
Starting the NC program:
Press "NC start". The selected program is started or continued after a stop of
the program sequence, according to the analyzer mode set.
Following deselection and reselection of an NC program, the analyzer mode
needs to be reset.
Ending the analyzer mode:
The analyzer mode is closed by pressing the F-key <F6> ("Restore operating
mode") in the topmost F-key level. The previously set operating mode appears
in the header.
Program window:
The "Program" window of the NC analyzer always shows the NC program that
is currently selected unless a different file was selected for display in the
"File" window.
If no NC program is selected in the NC, the "Program" window remains empty.
File window:
Selecting the program in the stack:
The "File" window shows the file system of the control. Every file located there
can be displayed via the file selection in the "Program" window.
Only active programs can be edited with the NC analyzer.
In the "File" window, go to the required program:
●
Using the mouse or
Advertisement
Table of Contents
