Table of Contents
Advertisement
Application Description | Rexroth IndraMotion MTX 09VRS
5.2.12
Tool Correction Register Display
Display Contents
Column Selection
●
Length correction L3
●
Radius correction R
●
Euler angle phi
●
Euler angle theta
●
Euler angle psi
●
Edge position
●
Active tool edge
●
Tool type
The display supports a maximum of 10 variants. If a date is not
available, "—" is displayed.
The tool correction register display is used to show all the tool correction reg‐
isters regarding all the tool edges.
Fig.5-18:
Tool correction register display
The columns and variants are selected using the variant editor of the options
dialog box. Variants with the following column data can be defined here.
●
Length correction L1
●
Length correction L2
●
Length correction L3
●
Radius correction R
●
Euler angle phi
●
Euler angle theta
●
Euler angle psi
●
Edge position
The display supports a maximum of 10 variants. If a date is not
available, "—" is displayed.
Electric Drives
| Bosch Rexroth AG
and Controls
General Operation and Visualization
37/233
Advertisement
Table of Contents
