Table of Contents
Advertisement
36/233
Bosch Rexroth AG | Electric Drives
General Operation and Visualization
Column Selection
5.2.11
Tool Correction Display
Display Contents
Column Selection
Rexroth IndraMotion MTX 09VRS | Application Description
and Controls
The columns and variants are selected using the variant editor of the options
dialog box. Variants with the following data can be defined here:
●
Active tool
●
Tool name Active Tool
●
Tool type Active Tool
●
Preselected tool
●
Tool name Preselected Tool
●
Tool type Preselected Tool
●
Active tool edge
●
D number index
●
D length compensation L1
●
D length compensation L2
●
D length compensation L3
●
D radius compensation R
●
D tool edge position
●
Tool length compensation L1
●
Tool length compensation L2
●
Tool length compensation L3
●
Tool radius compensation R
●
Tool edge position
●
Tool Euler angle phi
●
Tool Euler angle theta
●
Tool Euler angle psi
The display supports a maximum of 10 variants. If a date is not
available, "—" is displayed.
The tool correction display is used to show the D-correction, tool name, tool
type, external tool values and cumulative correction values.
Fig.5-17:
Tool correction display
The names of the active and preselected tools are extracted from
the tool database. To display the active tool, it is imperative to set
the active flag in the database from the PLC or the NC.
The columns and variants are selected using the variant editor of the options
dialog box. Variants with the following column data can be defined here.
●
Length correction L1
●
Length correction L2
Advertisement
Table of Contents
