Table of Contents
Advertisement
Application Description | Rexroth IndraMotion MTX 09VRS
11.4
Calculations and Tables
11.4.1
Introduction
Purpose of the Calculation
Set-up
Shortcut
The dialog "Calculations and tables", shortly called "Calculation", is a means
for performing calculations and for looking for values in tables that are fre‐
quently needed, especially in the creation of part programs (thread table, fit
sizes). It is a modal dialog that is exclusively available in the IndraWorks Op‐
erationDesktop of the IndraMotion MTX.
We do not accept any warranty for the correctness of the table val‐
ues.
Within this dialog, there is a calculator for general calculations and different
calculation forms are provided for frequently recurring geometrical and tech‐
nological calculations.
Depending on the form of the calling dialog, the calculator disposes of a pos‐
sibility to directly insert the result in the entry field last focused. Apart from that,
the result can be directly used at any place by inserting the content of the clip‐
board.
The calculator will only be available in the OperationDesktop if it has been set-
up.
Showing the calculator by means of a shortcut is the most frequent way for
calling the former. Particularly in dialog boxes - if they are prepared for that
purpose - shortcuts are the only way for calling.
Start the IndraWorks OperationDesktop. When doing so, use the menu bar
(show it using <ALT> +<M>, if necessary) and actuate "Tools" followed by
"Options...". In the dialog that is then shown open the node "General" and select
"Keyboard". Under "Categories:", select the entry "MTX Functions" and under
"Commands" the entry "Calculator". Set the entry focus to the field "Press key
combination:" and press the desired shortcut (key combination). The "Assign"
pushbutton activates the shortcut in connection with "OK" and/or "Accept".
Electric Drives
| Bosch Rexroth AG
and Controls
Extended Functionality
195/233
Advertisement
Table of Contents
