Displaying And Resetting An Active Fault; Parameters Mode; Overview - ABB ACS5000 User Manual

ABB
9.5.7

Displaying and resetting an active fault

9.6

Parameters mode

9.6.1

Overview

5k A UM
1 To display an active fault, press the ACT key.
2 To reset the fault, press the RESET key.
NOTICE
Running the drive system with incorrect data can result in improper oper-
ation, reduction of control accuracy and damage to equipment.
Parameters must only be set by qualified personnel. Do not change any
parameter, if the meaning of the parameter and the effects of the change
are not fully understood.
If the parameter lock is disabled or unlocked (see
unlocking a parameter
parameter settings for the required drive configuration depending on the
application.
The parameters are organized in functional groups, so called parameter
groups.
3BHS221906 ZAB E01 Rev. D
1 L ->
ACS 2000
FAULT
***
MCB CloseControl
1 L ->
StateINU
MOTOR SP
POWER
lock) the parameters mode allows entering the
Chapter 9 - CDP control panel
600.0 rpm
***
600.0 rpm
ReadyOn
0.00 rpm
0.0 kW
9.6.3 Enabling /
9-11 (24)