ABB
6.8.3
Routing the cables
6.8.4
Determining the cable length
6.8.5
Preparing the cable entry
5k A UM
•
Route the auxiliary power and the control cables through the cable
duct on the left side of the control compartment as indicated in
14.
Fig. 6-14
Routing control cables
•
Determine the required length of a cable between the point of entry
and the connection point inside the cabinet.
•
Cut the cable to the required length before connecting it to avoid
excess cable be stored in the cable ducts.
•
Remove the grommet from the outer entry plate (the outer entry plate
is only used with top cable entry).
3BHS221906 ZAB E01 Rev. D
Chapter 6 - Electrical installation
Fig. 6-
6-17 (22)