ABB
Preparing cables for EMC plates
5k A UM
The orientation of the EMC plates is the same for top and bottom cable
entry: the sealing grommets always face upwards.
1
Remove the grommets from the entry plate.
2
To ensure proper sealing, cut along the marking that corresponds to
the cable diameter.
3
Slide the grommet onto the cable. The grommet must fit tightly to
prevent water entering the cabinet.
The grommets can be discarded if cables are entered through the
cabinet floor.
4
If necessary, remove the entry plate and push the cable through the
entry holes.
5
Prepare the cables as illustrated in
■
(A)
illustrates how cables with an outer cable screen or shield are
prepared for EMC bonding with the metal enclosure of the
cabinet.
■
(B)
illustrates how cables without an outer screen or shield are
prepared
3BHS221906 ZAB E01 Rev. D
Chapter 6 - Electrical installation
Fig.
6-5.
6-9 (22)