ABB ACS5000 User Manual page 124

Chapter 9 - CDP control panel
Group 07 Control words
Group 08 Status words
Group 09 Fault and alarm words
Group 11 Start / stop / direction / MCB control
Group 12 Reference selection
Group 16 System control inputs
Group 17 DC-link control
Group 18 Utility
Group 19 Data storage
Group 20 Limits
Group 21 Start / stop / process stop
Group 22 Ramp functions
Group 23 Speed reference
9-12 (24)
For further information on the parameters, their settings and functions, see
Appendix G – Signal and parameter
When entering the parameters mode for the first time after the auxiliary
supply voltage of the drive has been switched on, the CDP control panel
displays the first parameter of parameter group 11. The next time the
parameters mode is entered, the previously selected parameter displays.
Some parameter values cannot be changed while the drive is running. If
tried, the following warning displays.
WARNING
**
WRITE ACCESS DENIED
PARAMETER SETTING
NOT POSSIBLE
3BHS221906 ZAB E01 Rev. D
21.01 Start function
21.02 Start function
21.03 Off1 stop mode
21.04 Process stop selection
21.05 Process stop signal
21.06 Process stop MCB control
21.07 Process stop mode
.
.
.
21.17 MCB closing time limi
21.17
21.19 MCB available signal
table.
**
ABB
t
5k A UM