Mitsubishi Electric MELSEC-Q Series User Manual page 195

5) Open the initial setting window for the D/A converter module (L60DA4) and set
parameters as follows.
Project window
6) Open the auto refresh window for the D/A converter module (L60DA4) and set
parameters as follows.
Project window
7) Write the parameters to the head module. Then reset the head module or turn off
and on the power.
[Online] [Write to PLC]
POINT
In this setting example, default settings are used for the parameters other than
those described. For the parameter setting, refer to the following.
• User's manual for the head module
• User's manual for the intelligent function module
[Intelligent Function Module]
[Intelligent Function Module]
or Power OFF ON
11 - 9
Chapter 11 PROGRAMMING
[L60DA4] [Parameter]
[L60DA4] [Auto Refresh]