Mitsubishi Electric MELSEC-Q Series User Manual page 70

(a) Setting the configuration of the slave station in the master station
Item
Set the mode of the master station. (Refer to Section
Mode Setting
7.3 (1).)
Select a link device assignment method.
• Point/Start: Enter the points and start numbers of
Assignment Method
• Start/End: Enter the start and end numbers of link
Link Scan Time
Displays the approximate link scan time.
(Approx.)
The total number of slave stations set in the CC IE
No.
Field configuration window is displayed.
The module model name is displayed.
If a module where the profile is not registered is set,
the message "Module without profile" is displayed.
Model Name
Register the profile before setting the model name.
For how to register a profile, refer to the "GX Works2
Version1 Operating Manual (Common)".
Enter the station number of each slave station
connected to the network.
Station numbers do not need to be set consecutively,
STA#
but must be unique.
The station number of the master station is fixed at
"0".
Select the station type (excluding the master station).
Station Type Select the station type same as that of the modules
connected to the network.
(Note-1): The range from the station No.1 to 4 is valid in the 4-axis module, and the range from the station No.1 to 8 is valid in the 8-axis
module.
Description
link devices.
devices.
Chapter 7 PARAMETER SETTING
Setting range
• Online (Normal Mode)
• Offline
(Default: Online (Normal Mode))
• Point/Start
• Start/End
(Default: Start/End)
1 to 120
(Default: Blank)
(1) Station No.1 to 16
• Intelligent Device Station
• Remote Device Station
(2) Station No.17 to 120
• Intelligent Device Station
• Remote Device Station
• Remote I/O Station
(Default: Intelligent Device Station)
7 - 10
Remark
•If the value
outside the
setting range is
set, "Parameter
error (error code:
D303H)" will
occurs and the
master station
will start with
offline mode.
–
–
–
(Note-1)
•If the value
outside the
setting range is
set, "Parameter
error (error code:
D628H)" will
occur.
–
–
–
–
–