Mitsubishi Electric MELSEC-Q Series User Manual page 230

Error code
Parameter error (device range
D615H
assignment error (RY))
Parameter error (device range
D616H
assignment error (RY))
Parameter error (device range
D617H
assignment error (RX))
Parameter error (device range
D618H
assignment error (RX))
D619H to D61AH Parameter error
Parameter error (device duplication
D61BH
(RWw))
Parameter error (device duplication
D61CH
(RWr))
Parameter error (device duplication
D61DH
(RY))
Parameter error (device duplication
D61EH
(RX))
D620H Incorrect transient data
D621H Parameter error
Parameter error (total number of
D622H
slave stations error)
Parameter error (block data
D625H
assurance per station setting error)
Parameter error (slave station
D627H
setting information error)
Error
• Write the network parameters to the CPU module again.
• Correct the value in the size of the link device in the slave station(s)
(setting data), and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the value in the offset of the link device in the slave station(s)
(setting data), and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the value in the size of the link device in the slave station(s)
(setting data), and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the value in the offset of the link device in the slave station(s)
(setting data), and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the value in the offset or the size of the link device in the slave
station(s) (setting data), and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Check the transient data at the request source, and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the total number of slave stations, and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the setting in "Block Data Assurance per Station", and retry the
operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
• Write the network parameters to the CPU module again.
• Correct the value in the slave station setting information (setting data),
and retry the operation.
• If this error persists, please consult your local Mitsubishi service center or
representative.
12 - 20
Chapter 12 TROUBLESHOOTING
Action